VAXBI bus

This article has multiple issues. Please help or discuss these issues on the talk page. (Learn how and when to remove these messages) The topic of this article may not meet Wik.ipedia.Pro's general notability guideline. Please help to demonstrate the notability of the topic by citing reliable secondary sources that are independent of the topic and provide significant coverage of it beyond a mere trivial mention. If notability cannot be shown, the article is likely to be merged, redirected, or deleted. Find sources: "VAXBI bus" – news · newspapers · books · scholar · JSTOR (November 2022) (Learn how and when to remove this message) This article needs additional citations for verification. Please help by adding citations to reliable sources. Unsourced material may be challenged and removed. Find sources: "VAXBI bus" – news · newspapers · books · scholar · JSTOR (November 2022) (Learn how and when to remove this message) (Learn how and when to remove this message)

The VAXBI bus (VAX Bus Interconnect bus) is a computer bus designed and sold by the Digital Equipment Corporation (DEC) of Maynard, Massachusetts.^[1]

The bus is an advanced, configuration-free synchronous bus used on DEC's later VAX computers. Like the Unibus and Q-Bus before it, it uses memory-mapped I/O but has 32-bit address and data paths. The VAXBI is a multiplexed bus with fully distributed arbitration and geographic addressing.

All of the logic required to implement a VAXBI interface is contained within a single custom integrated circuit (the "BIIC") and the physical layout and printed wiring board layout for compliant cards is tightly specified, right down to the location of the dual amber status LEDs that are required. The portion of the card that is reserved for the bus interface is referred to as "the VAXBI corner".^[2] VAXBI licensees were given the appropriate engineering drawings to allow them to exactly replicate a compliant card.

VAXBI expansion cards mount into backplanes using a ZIF connector; depending on the backplane design, cards can be loaded from the top or the front side of the backplane. No cable connections are permitted on the cards; all connections are made via three uncommitted rows of backplane connectors. Similarly, no configuration jumpers are permitted on the cards; all setup is done by jumpers inserted on the backplane connectors or via software configuration.

Originally conceived by its engineers to be an open bus, it was forced to be a tightly licensed bus by Digital's marketing and management, and was not nearly as successful as had originally been hoped-for.

It is used in the VAX 6000, VAX 8000 (82xx, 83xx, 85xx, 87xx, 88xx models) and the VAX 9000 systems and also on the MIPS R3000 based DECsystem 5800 series.

A PDP-11 implementation (the PDP-11/27) was envisioned but never advanced beyond the concept stage.